Bulletin of Earthquake Science and Engineering

Bulletin of Earthquake Science and Engineering

Evaluation of the Effects of Topography on the Horizontal and Vertical Displacement of Semi-Sine Shaped Hills against Ricker Waves

Document Type : Propagative Article

Authors
Mahyar Nobakht 1
Masood AmelSakhi 2
Fatemeh Sheshpari 1
1 M.Sc. Graduate of Geotechnical Engineering, Qom University of Technology, Qom, Iran
2 Assistant Professor, Department of Civil Engineering, Faculty of Engineering, Qom University of Technology, Qom, Iran
10.48303/bese.2021.245996
Abstract
This study presents the results of a numerical study on seismic behavior of two-dimensional semi-sine shaped hills that were subjected to vertically propagating incident SV wave of the Ricker wavelet. In the case of 2D response analysis of hills, different researchers studied the seismic response of triangular shaped hills under vertically propagating SH waves. Earthquakes are natural events that can have considerable economic and social injuries and have effects on people life and their environment. Geotechnical earthquake engineering has been noticed particularly in recent decades. Soil mass and soil structure response analysis against earthquake movements is one of the most important practical concepts in geotechnical earthquake engineering. This paper used finite difference method and represented that topography has specific effect on acceleration distribution in different points of roughness. The finite difference software is used to model and analyze the different sizes of the hills. Concentration is on topographic effects, so parameters such as the shape factor (the ratio of the height to half width of the hill) and the type of ground took into account in this research. The medium was assumed to have a linear elastic constitutive behavior. An important factor that affects on numerical results is the shape factor of the hills. Therefore, we modeled semi-sine hills with different shape factors (0.1, 0.4 and 0.8) subjected to Ricker wavelet with constant frequency on grounds with different properties that differ from each other in density and shear velocity (three types). The finite difference software used to run the numerical analyses was Flac 2D. The aim of this project was to investigate the response of topography effects on semi-sine shaped hills under Ricker wavelet, which is the second derivative of Gauss function. In this research, the horizontal and vertical displacements of different points on hills were calculated. Also, amplification factors were calculated from the ratio of horizontal components of motion to displacements of free-field model. The results are shown that both horizontal and vertical displacements were increased with a change in the shape factor as well as the amplification. It is shown that changing ground type from one to three, the displacements were reduced. Obtained results show that most horizontal displacement occurs in the top of the hill and as we reach the lowest height of the hill, this displacement decreases. Thus it can be seen that most amplification occurs in the top of the hill for different numerical models. The vertical displacement in top of the hill is zero and with decreasing the height of the hill, this vertical displacement increases and then decreases. Based on obtained results, the most vertical displacement occurs in the height between the top and down of the hill for different finite difference numerical models. Another important result is that these vertical and horizontal displacements depend mostly on soil geotechnical behavior of the hill. It is obvious that the shape factor of the hill affects on the obtained numerical results. An important factor that is studied in this research is the shape factor of the hill. Another important factor on which results are dependent is input motion frequencies. It is clear that when natural frequencies of the hill and the input motion frequencies are near to each other, the vertical and horizontal displacement increases. When the hill steep increases, the obtained results increase because of gathering most energy on top of the hill in a narrow band area.
Keywords
Semi-Sine Hills
Ricker Wavelet
Topography

Subjects

  1. Kramer S.L. (1996) Geotechnical Earthquake Engineering. Chapters: 2, 3, 5, 7, and 8, and Appendix A.
  2. Trifunac, M.D. and Hudson, D.E. (1971) Analysis of the Pacoima dam accelerogram San Fernando, California, earthquake of 1971. Bulletin of the Seismological Society of America, 61(5), 1393-1411.
  3. Boore, D.M. (1973) The effect of simple topography on seismic waves: implications for the accelerations recorded at Pacoima Dam, San Fernando Valley, California. Bulletin of the Seismological Society of America, 63(5), 1603-1609.
  4. Spudich, P., Hellweg, M., and Lee, W.H.K. (1996) Directional topographic site response at Tarzana observed in aftershocks of the 1994 Northridge, California, earthquake: implications for mainshock motions. Bulletin of the Seismological Society of America, 86(1B), S193-S208.
  5. Naganoh, M., Kagami, H., and Muratami, H. (1993) 'Effects of surface and subsurface irregularities'. In: Earthquake Motions and Ground Conditions. The Architectural Institute of Japan, Tokyo.
  6. Boore, D.M. (1972) A note on the effect of simple topography on seismic SH waves. Bulletin of the Seismological Society of America, 62(1), 275-284.
  7. Bouchon, M. (1973) Effect of topography on surface motion. Bulletin of the Seismological Society of America, 63(2), 615-632.
  8. Pedersen, H., Le Brun, B., Hatzfeld, D., Campillo, M., and Bard, P.Y. (1994) Ground-motion ampli-tude across ridges. Bulletin of the Seismological Society of America, 84(6), 1786-1800.
  9. Takenaka, H., Kennett, B.L.N., and Fujiwara, H. (1996) Effect of 2-D topography on the 3-D seismic wavefield using a 2.5-D discrete wavenumber-boundary integral equation method. Geophysical Journal International, 124(3), 741-755.
  10. Kamalian, M., Gatmiri, B., and Sohrabi-Bidar, A. (2003a). On time-domain two-dimensional site response analysis of topographic structures by BEM. Journal of Seismology and Earthquake Engineering, 5(2), 35-45.
  11. Kamalian, M., Jafari, M.K., Sohrabi-bidar, A., Razmkhah, A., and Gatmiri, B. (2006) Time-domain two-dimensional site response analysis of non-homogeneous topographic structures by a hybrid BE/FE method. Soil Dynamics and Earthquake Engineering, 26(8), 753-765.
  12. Sohrabi-Bidar, A. (2008) Seismic Behavior Assessment of Surface Topographies Using Time-Domain 3D Boundary Elements Method. Ph.D. Thesis, International Institute of Earthquake Engineering and Seismology (IIEES), Iran.
  13. Sohrabi-Bidar, A., Kamalian, M., and Jafari, M.K. (2009) Time-domain BEM for three-dimensional site response analysis of topographic structures. International Journal for Numerical Methods in Engineering, 79(12), 1467-1492.
  14. Sohrabi-Bidar, A., Kamalian, M., and Jafari, M.K. (2010) Seismic response of 3-D Gaussian-shaped valleys to vertically propagating incident waves. Geophysical Journal International, 183(3), 1429-1442.
  15. Sohrabi-Bidar, A., Kamalian, M., and Jafari, M.K. (2011) Seismic waves scatteringin three-dimensional homogeneous media using time-domain boundary element method. Earth and Space Physics, 38, 23-40.
  16. Assimaki, D. and Gazetas, G. (2004) Soil and topographic amplification on canyon banks and the 1999 Athens earthquake. Journal of Earthquake Engineering, 8(01), 1-43.
  17. Wang, Y. (2015) Frequencies of the Ricker wavelet. Geophysics, 80(2), A31-A37.
  18. Nazari, A., Baziar, M., and Shahnazari, H. (2010) Seismic effects of two-dimentional semi-sine shaped hills on ground motion response Journal of Geotechnical Engineering, 15.

  • Receive Date 12 July 2020
  • Revise Date 26 October 2020
  • Accept Date 03 February 2021